Table of Contents
Advertisement
Basic Operations
4.
Set a value for the Communications Timeout, measured in 1/10ths of a second, where 0 is a valid value. If
no timeout is required, use -1.
5.
If you want to enable Control Failure Detect, place a check in the box next to it.
6.
Click the radio button for the Support Module that fits your device template.
7.
Click Next. The next page is Device Template Final page.
8.
Within the Save Template to field, either type or click Browse to select the target location to save your
template file (.CGT).
9.
Click Finish to create the template file and save it.
Opening An Existing Project
If you have already created a project (.CGP) and would like to use it as a starting point, follow these steps:
1.
With the RMS CodeCrafter wizard open to the Introductory page, click Open Project.
2.
In the Open RMS CodeCrafter Project window, navigate to your project and click Open.
You can now begin working from your saved project.
Closing A Project Or Template File
Once you are done with a project or template file, but would like to keep RMS CodeCrafter open, you can
close the file. To close a file:
Importing RMS SDK Spreadsheets
Earlier releases of RMS SDK utilized an Excel spreadsheet that RMS CodeCrafter now replaces. You can
import your device and parameter information from the Excel spreadsheet into RMS CodeCrafter.
1.
Select File > Open > Import Spreadsheet.
2.
Browse to your desired .XLS file and click Open.
44
Projector
Transport
Basic
Slide Projector
None
Select File > Close. If you have not already saved your file you are prompted to do so at this time.
RMS CodeCrafter
Advertisement
Table of Contents
