Allied Telesis AT-RPS9700 Installation Manual

AT-RPS9700 Power Supply Chassis &
AT-PWR9700 Power Module

Installation Guide

Allied Telesis S.A.
Via Motta 24
6830 Chiasso
Switzerland
Visit our website at www.alliedtelesyn.com
Overview
The AT-RPS9700 can supply redundant power for up to two
AT-9700 Series Ethernet switches. It provides external power
to the switch should the primary (internal) power supply unit
fail. Initially, it contains no power module, but can house up to
two AT-PWR9700 power modules. Each AT-PWR9700 power
module can support one switch. You can purchase additional
power modules from your Allied Telesyn supplier.

Related Documents

The Allied Telesyn web site at www.alliedtelesyn.com offers
you an easy way to access the most recent documentation,
software, and technical information for all of our products. For
details on the features and functions of your Allied Telesyn
AT-9700 Series Gigabit Ethernet Switch, refer to the following
manuals from our web site:
❑ AT-9724TS Series Gigabit Ethernet Switch Installation
Guide
PN D617/10032
Package Contents for the AT-RPS9700 Power
Supply Chassis
Make sure the following items are included in the shipping
package. If any item is missing or damaged, contact your
Allied Telesyn sales supplier for assistance.
❑ AT-RPS9700 Power Supply Chassis
❑ Installation Guide
❑ Warranty Card
Package Contents for an AT-PWR9700 Power
Module
If you have purchased the AT-PWR9700 power module,
make sure the following items are included in the shipping
package. If any item is missing or damaged, contact your
Allied Telesyn sales supplier for assistance.
❑ AT-PWR9700 Power Module
❑ DC Power Cord
❑ AC Power Cord (USA) for operation in USA/Canada
❑ AC Power Cord (UK) for operation in United Kingdom
❑ AC Power Cord (Europe) for operation in Europe
❑ Installation guide
❑ Warranty card
Caution
Before installing the AT-RPS9700 power supply, refer to
Appendix B in the AT-9700 Series Fast Ethernet Switch
Installation Guide for electrical safety and emission
information.
Installing an AT-RPS9700 Power Supply Unit
Note
The redundant power supply should be installed close to the
switches so that you can easily connect the RPS cables to
the unit. It is recommended that you install the redundant
power supply directly above or below your AT-9700
Series Gigabit Ethernet switch or in a directly adjacent rack.
Perform the following procedure to install the power supply
chassis in a standard 19-inch rack.
1. Mount the AT-RPW9700 Power Supply Chassis in the 19-
inch rack using standard screws (not provided).
2. Insert an AT-PWR9700 Power Module into one of the
empty slots in the AT-RPS9700 chassis.
3. Tighten the screws holding the AT-PWR9700 Power
Module in place.
4. Attach the provided DC power cord to the DC connector on
the back panel of the AT-RPS9700 power supply.
5. Connect the other end of the DC power cord to the RPS
Input connector on the back panel of the switch.