Reading Mib Files - Alcatel-Lucent AOS-W 3.4 MIB Reference Manual

Rx Bytes per AP BSSID (32-bit counter)
apBSSRxBytes
snmpwalk -v 2c -c <snmp community name> <switch IP addr>
.1.3.6.1.4.1.14823.2.2.1.1.3.5.1.11 | grep "<ap bssid in decimal format>"
Total Bandwidth per AP BSSID (kbps)
apBSSBwRate
Free Memory
sysXMemoryFree
snmpget -v 2c -m ALL -c <snmp community name> <switch IP addr>
.1.3.6.1.4.1.14823.2.2.1.1.1.11.1.4.1
SNR of Wireless Devices per AP
staSignalToNoiseRatio
snmpwalk -v 2c -c <snmp community name> <switch IP addr>
.1.3.6.1.4.1.14823.2.2.1.1.2.2.1.7 | grep "<ap bssid in decimal format>"
SNR of APs
apSignalToNoiseRatio
snmpwalk -v 2c -c <snmp community name> <switch IP addr>
.1.3.6.1.4.1.14823.2.2.1.1.3.3.1.14 | grep "<ap bssid in decimal format>"

Reading MIB Files

This section describes how to interpret the basic components of a MIB file. To determine the OIDs,
viewing the file snmp.h may be necessary, which is described in
information about MIB files, see
"SNMP MIBs Reference" on page
MIB files describe a specific component of a network device. The files are numerical strings that are
converted to ASCII text by the compiler of the SNMP manager. A word processor or text editor can be
used to open the ASCII file. The contents of an example Aruba enterprise MIB file, aruba-cts.my, are
described below.
Opening Line
Following is the opening line, the beginning of the MIB file.
WLSX-CTS-MIB DEFINITIONS ::= BEGIN
28 | Using MIBs
snmpwalk -v 2c -c <snmp community name> <switch IP addr>
.1.3.6.1.4.1.14823.2.2.1.1.3.5.1.12 | grep "<ap bssid in decimal format>
.1.3.6.1.4.1.14823.2.2.1.1.3.5.1.11
.1.3.6.1.4.1.14823.2.2.1.1.3.5.1.12
.1.3.6.1.4.1.14823.2.2.1.1.1.11.1.4
.1.3.6.1.4.1.14823.2.2.1.1.2.2.1.7
.1.3.6.1.4.1.14823.2.2.1.1.3.3.1.14
MIBs on page 19. For a listing of SNMP MIB OIDs, see
509.
SNMP File on page 32. For additional
Chapter 21,
AOS-W 3.4 MIB | Reference Guide