Wall Mounting - Onkyo HTP-501 Instruction Manual

Getting to know Your Speaker Package—Continued

Wall Mounting

The speakers can easily be wall mounted by using the
keyhole slots. To prevent the speaker from vibrating
against the wall, attach four of the supplied spacers to the
keyhole fins on the rear of each speaker.
■ Mounting vertically
To mount the front speakers vertically, use the keyhole
slot shown to hang each speaker on a screw that's
securely screwed into the wall.
Keyhole slot for
vertical wall
mounting
Caution:
A mounting screw's ability to support a speaker depends
on how well it's anchored to the wall. If you have hollow
walls, screw each mounting screw into a stud. If there are
no studs, or the walls are solid, use suitable wall anchors.
Use screws with a head diameter of 9 mm or less and a
shank diameter of 4 mm or less. With hollow walls, use
a cable/pipe detector to check for any power cables or
water pipes before making any holes.
Leave a gap of between 5 mm and 10 mm between the
wall and the base of the screw head, as shown.
Wall
5 mm – 10 mm
(We recommend that you consult a home installation
professional.)
Subwoofer (SKW-501)
■ Front
Rubber spacers
■ Rear
A
B
C
Note:
The Auto Standby function turns the subwoofer on when
the input signal exceeds a certain level. If the Auto
Standby function does not work reliably, try slightly
increasing or decreasing the subwoofer output level on
your DVD/AV receiver.
■ Using Floor Pads with Subwoofer
If the subwoofer is placed on a hard floor (wood, vinyl,
tile, etc.) and playback is very loud, the subwoofer's feet
may damage the flooring. To prevent this, place the sup-
plied pads underneath the subwoofer's feet.
The pads also provide a stable base
for the subwoofer.
2 3
To AC outlet
STANDBY/ON indicator
Red: Subwoofer in standby mode
Blue: Subwoofer on
With the Auto Standby function, the SKW-501
automatically turns on when an input signal is
detected in Standby mode. When there's no input
signal for a while, the SKW-501 automatically
enters Standby mode.
OUTPUT LEVEL control
This control is used to adjust the volume of the sub-
woofer.
LINE INPUT
This RCA input should be connected to the sub-
woofer pre out on your DVD/AV receiver with sup-
plied RCA cable.
1
5
En-