Controlling Av Components That Are Out Of Range - Onkyo BD-SP808 Instruction Manual

Controlling AV Components that are Out of Range

You can use the following multi-room kits to control the BD-SP808 when it's out of range of the remote controller:
• Multiroom kits such as those made by Niles and Xantech.
Controlling Other Out-of-Range AV Components
If another AV component is out of range of its remote controller, you can use a commercially available IR emitter to
retransmit the remote controller signals received at the BD-SP808's IR IN jack, as shown below.
Connect the IR emitter to the BD-SP808's IR OUT jack, and place the IR emitter in front of the other AV component's
remote control sensor (usually located on its front panel), as shown below. See the instructions supplied with the IR
emitter.
Only remote controller signals received by the BD-SP808's IR IN jack are fed through to the IR OUT jack. Signals picked up
by the BD-SP808's remote control sensor are not output.
20
CONNECTIONS
Connecting
block
IR IN
IR OUT
BD-SP808
IR emitter
Other
compo-
nent
from
connecting block
Miniplug cable
IR
IN
BD-SP808
IR
IN
RS232
Signal flow
Remote controller
Other component
Remote control
sensor
IR emitter
Miniplug
IR emitter
Signal flow
IR
IN
EN