Agilent Technologies InfiniiVision 3000 X-Series User Manual page 320

22
CAN/LIN Triggering and Serial Decode
2 Choose whether to include the parity bits in the identifier field.
3 If the decode line does not appear on the display, press the [Serial] key
4 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and
If the setup does not produce a stable trigger, the LIN signal may be slow enough that the
N O T E
oscilloscope is AutoTriggering. Press the [Mode/Coupling] key, then press the Mode
softkey to set the trigger mode from Auto to Normal.
You can use the horizontal Zoom window for easier navigation of the
decoded data.
See Also
•
•
•
320
a If you want to mask the upper two parity bits, ensure that the box
under the Show Parity softkey is not selected.
b If you want to include the parity bits in the identifier field, ensure
that the box under the Show Parity softkey is selected.
to turn it on.
decode data.
"Interpreting LIN Decode"
"Interpreting LIN Lister Data"
"Searching for LIN Data in the Lister"
on page 321
on page 322
Agilent InfiniiVision 3000 X-Series Oscilloscopes User's Guide
on page 323