Follett HCC1400A Operation And Service Manual page 6

Dimensions and clearances
Entire front of icemaker must be clear of obstructions/connections to allow removal.
1" (26mm) clearance above icemaker for service.
1" (26mm) minimum clearance on sides.
The intake and exhaust air grilles must provide at least 170 sq in (968 sq cm) of open area.
Air-cooled model HCC1400A icemakers – 18" (458mm) minimum clearance between discharge and air
intake-grilles.
Front View
Air intake
Side View
21.28" (541mm)
23.50"
(597mm)
Easton Pennsylvania
CORPORATION
MODEL SERIAL NO PART NO
FULL LOAD AMPS VOLTS HZ SINGLE
PHASE
Stock Module Identification Plate 208264 MOTOR COMPRESSOR THERMALLY PROTECTED
REFRIGERANT CHARGE OZ
Module No.
Product DESIGN PRESSURE HIGH SIDE LOW SIDE PSIG
Service No.
MIN. BRANCH CIRCUIT AMPACITY AMPS U U
L L NSF MADE IN
MAX. BRANCH CIRCUIT FUSE SIZE AMPS R R THE USA
C
21.05" (535mm)
23.8" (580mm)
Ice transport hose connection
NEMA 6-20
right angle
Air exhaust
both sides
G
1/4" FPT
condenser inlet
1/4" FPT
condenser drain
15.56"
(395mm)
6.97"
(177mm)
2.53"
(64mm)
2.72"
(69mm)
3/8" OD push-in water inlet
3/4" MPT drain
6
Back View
Air exhaust
29.63" (753mm)
2.43" (62mm)