Series Record And Split Slave Control Modes; Series Record; Split Slave - Focus ProHD DR-HD100 User Manual

Series Record and Split Slave Control Modes

Two additional control modes are available when the DR-HD100
is teamed up with the JVC GY-HD100/101 camcorder:
and
Record
either
Series
1394 REC TRIGGER
mode for these modes to function, see "JVC GY-HD" on page 30.

Series Record

Series Record automatically starts recording to disk when a tape is close
to the end of the record session. For more information about what
happens once recording to disk begins, refer to the camcorder
documentation.

Split Slave

In Split Slave mode, the GY-HD100/101 camcorder controls the DR-
HD100 separately from the camcorder's tape transport. The DR-HD100
is slaved to the camcorder's
GY-HD100/101's left panel.
• Every time the Rec Trigger is pressed, the DR-HD100 begins
recording in the selected recording mode.
• When the Rec Trigger is pressed again, the DR-HD100 enters
REC/PAUSE
Record mode.
• Pressing the Rec Trigger a third time, restarts recording. A
new track is created on the disk. Refer to camcorder
documentation for more information.
GY-HD100 OTHER→BACK SPACE[HDV] Setting
When using this mode, be certain to set the GY-HD100/101's
OTHER→BACK SPACE[HDV] menu to P-1394.
With this setting there is a slightly delayed response to the record
trigger.However, when OTHER→BACK SPACE[HDV] is set to P-
TAPE, the stream that the DR-HD100 records will contain
discontinuities at every point that recording to tape is initiated. This will
result in the loss of content.
ProHD DR-HD100 Portable DTE Recorder
. To access these control modes, select
Split Slave
or mode from the GY-HD100/101 camcorder's
Split
menu. The DR-HD100 must be in
REC TRIGGER
mode. The only exception is if it is in Retro
Series
JVC GY-HD
button, located on the
Quickstart
31