Table of Contents
Advertisement
Host configuration
This page provides the opportunity to configure various details for each of
the host systems that may be connected to the ALIF 2112T. Each entry can be
configured with a name, the permitted users, the hot key combinations required
to switch to it and, if required, appropriate power control commands.
Sort
Allows you to reorder the list of hosts either alphabetically or by entry number.
Erase Host Configuration
Removes all hosts from the list.
To get here
1 Using VNC viewer or a browser, log on as the 'admin' user.
2 Click the 'Configure' button in the top right corner.
3 Click the 'Host Configuration' option.
To create a new host entry
1 Click one of the host entries to reveal a Host configuration dialogue.
Name
Enter the name that will be displayed in the viewer window when you
click the Host button.
Users
Select the users that will be permitted to connect to this host. Either
enter
to allow all users or a list of users separated by commas.
*
KVM Switch Macro
Declare the hot key sequence that will cause the KVM switch to link
with the required host system. See
details.
Hotkey Host Number
Declare the numeric sequence that is pressed together with the VNC
viewer hotkeys (usually Ctrl + Alt) to select this host system, which is the
same value as the KVM port number.
Power On
Enter the code required to make an attached power control unit apply
power to the host. See
Power switching configuration
Power Off
Enter the code required to make an attached power control unit remove
power from the selected host.
Reboot
Enter the code required to make an attached power control unit remove
power and then re-apply it a few seconds later.
2 Enter the required information in each field.
3 Click the OK button.
Appendix J - Hotkey sequences
for
for details.
38
Advertisement
Table of Contents
