Miele KWL 4712 S ed Operating And Installation Manual page 33

It is important to check that the side
section of the handle d does not
come into contact with the door seal
when opening the door, as this
would damage the door seal
permanently.
If, after you have refitted the handle,
you find that the side section does
touch the door seal when the door is
opened:
Realign mounting plate c with grub
screws a until the mounting plate and
the side section of the handle d are at
the correct angle and the side section
does not touch the door seal when the
door is opened.
Changing over the door lock
^ Open the appliance door.
^ Remove the key from the door lock.
^ Remove cover a by inserting a
flathead screwdriver into the notch in
the cover (see arrow).
^ Remove both screws b from the lock
mounting.
^ Remove lock c together with the
lock mounting. To do this you can
insert the key in the lock and then
use the key to pull out the lock.
Changing the door hinging
^ Place the lock in front of you as
shown and use a flathead
screwdriver to lever safety disc d
upwards and out.
^ Remove lock lever e from the lock.
^ Hold the lock mounting in your hand
as shown.
^ Press the lock down and turn it 90°
as far as it will go.
^ Replace lock lever e turned through
180 ° (as shown).
33