Installation Instructions KWT4154 UG-1 en-CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
If there are any questions regarding the electrical connection of this appliance to the power supply, please consult a licensed electrician or call the Miele Technical Service. V1-800-565-6435...
Installation This appliance must be built in; Climate range Ambient room temperature otherwise it could tip over. +10°C to +32°C +16°C to +32°C +18°C to +38°C To ensure that the appliance +18°C to +43°C functions correctly in tropical SN-ST +10°C to +38°C climates where the ambient SN-T +10°C to +43°C...
Changing the door hinging The appliance is supplied right-hand hinged. If left-hand door hinging is required, follow the instructions below. ^ Unscrew the top hinge plate e, turn it around, and refit it on the opposite side. ^ Close the door, and unscrew the top ^ Unscrew the lower hinge plate f.
Page 5
Changing the door hinging ^ Swap over the plug h and the hinge pin guide i in the top of the door. ^ Hang the door on the lower hinge pin j, and close the door k. ^ Refit the top hinge pin l through the hinge pin plate into the door.
Under-counter installation Appliance dimensions Preparing the appliance ^ With two people, carefully tip the appliance backward. ^ Attach the supplied trim panel a below the appliance, and loosely tighten the screws b. ^ Arrange the trim panel a over the long holes in the appliance door recess.
Page 7
Under-counter installation Fitting the appliance into place ^ Slide the appliance into the installation area. Ensure that the power cord does not get caught. Make sure the power socket remains accessible. ^ Using the attachment strip and screws, fit the appliance into place.
Page 8
Subject to change without notice / 3208 M.-Nr. 06 873 220 / 00 KWT 4154 UG-1...