Table of Contents
Advertisement
7 5
b
e
^ Position the spring clamps a and the
safety brackets e supplied in the
positions shown in the illustrations in
"Appliance dimensions and Worktop
cut-out" pages by placing them on or
flush with the the upper edge of the
cut-out as shown above, and then se-
cure them with the 3.5 x 25 mm
screws supplied.
14
^ Feed the connection cable down
through the cut-out.
^ Lightly position the hob on the spring
clamps a .
^ Using both hands press down evenly
on the sides of the hob until it clicks
into position. When doing this make
sure that the seal under the hob sits
flush with the worktop on all sides.
This is important to ensure an effec-
tive seal on all sides. The hob can
now only be removed with a special
tool.
^ Now connect the connection cable to
the mains power supply. See "Electri-
cal connection".
Hide quick links:
Advertisement
Table of Contents
