Table of Contents
Advertisement
^ Make the worktop cut-out following
the dimensions shown above.
^ Remember to maintain a minimum
safety distance of 50 mm between
the hob and the back wall and a side
wall to the right or left of the hob. See
"Warning and Safety instructions".
^ Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture.
The materials used must be heat re-
sistant.
^ A protective base must be installed
underneath the hob. There must be a
gap of at least 15 mm between the
hob and the base (see illustration).
i n .
m
5 0
1 0
1 5
If during installation the corners of
the frame are not flush with the
worktop surface, the corner radius,
Max R4 can be carefully scribed to
suit.
13
Hide quick links:
Advertisement
Table of Contents
