Table of Contents
Advertisement
Fit wall units and extractor hood be-
fore fitting the hob, to avoid damag-
ing the ceramic surface.
The veneer or laminate coating of
worktops (or adjacent kitchen
units) must be treated with 100°C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of heat-resis-
tant material.
Ideally the hob should be installed
with plenty of space on either side.
There may be a wall at the rear and a
tall unit or wall at one side. On the other
side, however, no unit or divider should
stand higher than the hob (see illustra-
tions).
This equipment is not designed for
maritime use or for use in mobile
installations such as caravans, aircraft
etc. However it may be suitable for
such usage subject to a risk assess-
ment of the installation being carried
out by a suitably qualified engineer.
a Minimum distance between
cut-out and tall unit/wall = 50 mm,
unless they are made from a
non-combustible material.
See: Installation of appliance on
wall with additional niche cladding.
recommended
possible, but not recommended
not allowed
3
Hide quick links:
Advertisement
Table of Contents
