Table of Contents
Advertisement
All electrical work should be carried
out by a suitably qualified and com-
petent person, in strict accordance
with national and local safety regula-
tions.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer can-
not be held responsible for un-
authorised work.
Ensure power is not supplied to the
appliance while installation work is
being carried out.
The appliance must only be oper-
ated when built-in. This is to ensure
that all electrical parts are shielded.
Live parts must not be exposed.
The
given on the
these match the household mains sup-
ply.
Connection should be made via a suit-
able isolator which complies with na-
tional and local safety regulations, and
the On/Off switch should be easily ac-
cessible after the appliance has been
built in.
For extra safety it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA (in accordance
with DIN VDE 0664, VDE 0100 Section
739).
are
. Ensure that
When switched off there must be an
all-pole contact gap of at least 3 mm in
the isolator switch (including switch,
fuses and relays according to EN 60
335).
The appliance is supplied for connec-
tion to an a.c. single phase 230-240 V,
50 Hz supply with a 3-core cable.
The wires in the mains lead are col-
oured in accordance with the following
code:
Green/yellow = earth
Blue
= neutral
Brown
= live
The electrical safety of this appliance
can only be guaranteed when continu-
ity is complete between the appliance
and an effective earthing system, which
complies with local and national regula-
tions. It is most important that this basic
safety requirement is tested by a quali-
fied electrician. The manufacturer can-
not be held responsible for the conse-
quences of an inadequate earthing sys-
tem such as an electric shock.
The manufacturer cannot be held lia-
ble for damage which is the direct or
indirect result of incorrect installation
or connection.
17
Hide quick links:
Advertisement
Table of Contents
