Flymo Sabre Trim Owner's Manual page 5

H
Auto Line Feed System
How the automatic line feed works (H)
1. When initially switching on the trimmer, a small length
2. A 'clattering' noise will be heard when the nylon line
•
3. If the noise of the nylon line being cut cannot be
4. To feed more line, it is first necessary to to allow the
line cutter
5. Repeat step 4. until you hear the line hitting against the
6. If problems are experienced with the automatic line
of line is fed out.
hits the line cutter. DO NOT BE ALARMED this is
quite normal. After approximately 5 seconds the line
will be cut to the correct length and the noise will
reduce as the motor reaches full speed.
Make sure the motor is up to full speed before
trimming or edging.
heard, more line will need to be fed out.
motor to stop completely, then re-start, allowing the
motor to reach full speed.
cutter. (Do not repeat this procedure more than 6 times)
feed refer to Fault Finding Chart.