Adaptec 5085 Installation And User Manual page 79

Power off your computer, disconnect the power cord, then open the cabinet following the
4
manufacturer's instructions.
Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
5
flash connector.
Note:
To locate the Mode 0 flash connector on your Adaptec RAID controller, see the
figures in About Your RAID Controller on page
label on the flash connector is "HDA mode."
Reconnect the power cord, power on your computer, then boot to the drive containing the
6
AFU.exe file (see Step 3).
At the prompt, type
7
<drive-letter>:\afu
where is the drive identifier (
drive-letter
controller number.
Note:
You will be prompted to insert other disks, as needed.
When the flash is complete, power off your computer, disconnect the power cord, then
8
remove the jumper.
Close the computer cabinet, reconnect the power cord, then power on your computer.
9
The controller should boot correctly.
Chapter 10: Solving Problems
17. On Adaptec Series 6/6E controllers, the
update /c x
for a floppy drive, for instance) and
a
79
●
is the
x