Configuring The Sound Driver - Intergraph InterServe 80 System Setup

u
Install the latest Windows NT Service Pack from CD-ROM to update the operating
system. See "Getting Operating System Updates" later in this chapter.
Do the following after you install the Windows NT Service Pack:
u
If you created a Quick-Fix Engineering (QFE) backup diskette from Version Manager
during any previous initial system configuration, install the QFE update software. See
the
README
u
Configure IDE/ATAPI Bus Mastering as described later in this chapter.
u
Configure SCSI host adapter settings, if you previously used the SCSI Configuration
Utility on the SYSUTIL diskette to change SCSI host adapter settings. See
"Configuring SCSI Peripherals" in Chapter 3.

Configuring the Sound Driver

If you reinstall Windows NT and the associated system software, you should configure the
sound driver to ensure quality audio capability.
To configure the sound driver:
1. Click Start, Programs, Accessories, Multimedia, and then click Volume Control. The
Master Out window displays.
2. From Options, click Properties. The Properties dialog box displays.
3. Click Playback. In the Volume Controls list, click Master Out, SRS, Wave, and CD;
then click OK.
4. In the Master Out window, set all volume sliders to maximum.
5. From Options, click Properties. The Properties dialog box displays.
6. Click Recording. In the Volume Controls list, click Master Record and Mic; then click
Close.
7. In the Master Record window, set all volume sliders to maximum.
8. From Options, click Properties. The Properties dialog box displays.
9. Click Other. In the list, click Mic; then click Close.
10. In the Low Priority Input window, set the volume slider to maximum.
11. From Options, click Exit.
. file on the QFE diskette for more information.
TXT
77