ZyXEL Communications Comet 3356 User Manual page 37

Command
&Q0
&Q5(default)
&Q6
&S0(default)
&S1
&T0
&T1
&T8
&V
&Wn
&Yn
&Zn=x
%C0
%C1
%C2
%C3(default)
%E0
%E1
%E2(default)
%E3
%L
%Q
\A0
\A1(default)
\A2
\A3
\Bn
\G0(default)
\G1
\Kn
Break
transmitted from
PC
\K0 Enter command
mode
\K1 Clear buffers and
send break
\K2 Enter command
mode
30 AT Command Set Summaries
Function
Asynchronous mode selection
Select direct asynchronous operation
Try to negotiate an error-corrected link (using S36)
Select asynchronous operation in normal mode (speed
buffering)
DSR is always ON
DSR is active from answer tone detected to carrier drop
Terminate test in progress
Initiate a local analog loopback test
Initiate a local analog loopback with self-test
Display current configuration and saved profiles
Store the active profile as NVRAM profile n (n=0 or 1)
Set power-up default profile to n (n=0 or 1)
Store dial string x (up to 35 digits) to NVRAM (n=0 to 3)
Disable data compression
Enable MNP5 data compression negotiation
Enable V.42bis data compression
Enable both V.42bis and MNP5 data compression
Disable line quality monitor and auto-retrain
Enable line quality monitor and auto-retrain
Enable line quality monitor and fallback/fall forward
Enable line quality monitor and auto-retrain, but hang-up
immediately when EQM reaches hang-up threshold
Report received line signal level
Report line signal quality
64 characters maximum MNP block size
128 characters maximum MNP block size
192 characters maximum MNP block size
256 characters maximum MNP block size
Send break of length n * 100ms (n=1 to 9,default=3)
Disable modem to modem flow control (XON/XOFF)
Enable modem to modem flow control (XON/XOFF)
Set break handling:
\B command
received
Clear buffers and
send break
Clear buffers and
send break
Immediately send
break to remote
Break received from
remote
Clear buffers and send
break to PC
Clear buffers and send
break to PC
Immediately send
break to PC