ZyXEL Communications Comet 3356 User Manual page 50

S30 - Disconnect Inactivity Timer
Sets the length of time, in tens of seconds, that the modem will stay online before
disconnecting when no data is sent or received. In error-correction mode, any data
transmitted or received will reset the timer. In other modes, any data transmitted will
reset the timer. Set S30=0 to disable the timer.
S32 - XON Character
Sets the value of the XON character.
S33 - XOFF Character
Sets the value of the XOFF character.
S36 - LAPM Failure Control
This register is read when the S48 register contains the value 128 or if an attempted
error correction link fails. These fallback options are initiated immediately upon
connection if S48=128.
Bit Value
bit 0,1,2 000
001
010
011
100
101
110
111
S37 - Desired Line Connection Speed
Sets the value of the line connection speed.
bit 0-4 Desired line connection speed. This is interlinked with the Fn command. If an invalid number is entered,
the number is accepted into the register, but S37 will act as if the default value has been entered.
0 = Attempt auto mode connection. (default)
1-3 = Attempt to connect at 300 bps.
4 = Reserved.
5 = Attempt to connect at V.22 1200 bps.
6 = Attempt to connect at V.22bis 2400 bps.
7 = Attempt to connect at V.23.
8 = Attempt to connect at V.32 bis/V.32 4800 bps.
9 = Attempt to connect at V.32 bis/V.32 9600 bps.
10 = Attempt to connect at V.32 bis 12000 bps.
11 = Attempt to connect at V.32 bis 14400 bps.
12 = Attempt to connect at V.32 bis 7200 bps.
bit 5-7 Reserved.
S38 - Delay Before Forced Hang Up
Action
Modem disconnect.
Modem stays on-line and Direct mode connections established.
Reserved.
Modem stays on-line and a Normal mode connection is established.
An MNP connection is attempted and if it fails, the modem disconnects.
An MNP connection is attempted and if it fails, a direct mode connection is established.
Reserved.
An MNP connection is attempted and if it fails, the normal mode connection is established.
(default)
Status Registers & Result Codes 43