Main Menus - Teledyne 4060 Series Instruction, Operating And Maintenance Manual

Series 4060
2. The MAIN MENU and SUB MENU screens have a flashing
arrow on the left side indicating which item is being pointed
to.
3. MODIFIABLE ITEM screens have a flashing value
somewhere in the line.
4.6.4.1 M M
AIN
The MAIN MENU consists of 15 functions you can use to customize
and check the operation of the analyzer. They are listed here with brief
descriptions:

Set up and/or start a span calibration
SPAN:

ALT-SPAN

MODEL:
version of the instrument.

SELF-TEST:
routine to check the integrity of the power supply, output
boards, cell and amplifiers.

ALARMS:
whether each alarm will be active or defeated, HI or LO
acting, and failsafe or not.

RANGE:
switched manually.
 ANALOG-OUT ADJUST: Adjust the analog output with
offset and scaling.

LINEARIZATION

CHANGE STREAM
switch for using alternate gases. Has no effect during span
mode (span gas relay setting used at that time).

AUTO-CAL:
calibration sequence. AUTOCAL is an optional feature not
included in the standard configurations of the 4060.

: Low level application specific timing parameters.
TIMING
Factory set. Do not change these.
Teledyne Analytical Instruments
ENUS
: Set up and/or start an alternate span calibration.
Displays Manufacturer, Model, and Software
The instrument performs a self-diagnostic
Used to set the alarm setpoints and determine
Used to set up three analysis ranges that can be
: Linearization option.
: (optional feature) Controls a relay
Used to define and/or start an automatic
Operation
49