Table of Contents
Advertisement
4 Operation
Use < > arrows to blink
set appears.
Press < > arrows to blink
won't be able to set
... (or
Use
arrows to set an interval value, then use < > arrows to move to
the start-time value. Use
To turn
the
System again, choose
values screen appears, use the < > arrows to blink the
field. Use
now turn these fields
4.3.3 Password Protection
If a password is assigned, then setting the following system parameters
can be done only after the password is entered: span and zero settings,
alarm setpoints, analysis range definitions, switching between autoranging
and manual override, setting up an auto-cal, and assigning a new password.
However, the instrument can still be used for analysis or for initiating a self-
test without entering the password.
If you have decided not to employ password security, use the default
password
. This password will be displayed automatically by the
microprocessor. The operator just presses the Enter key to be allowed total
access to the instrument's features.
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.
4.3.3.1
To install a new password or change a previously installed password,
you must key in and ENTER the old password first. If the default password
is in effect, pressing the ENTER button will enter the default
word for you.
4-6: Part I
, and press Enter . A new screen for
), then press Enter again. (You
(or
to
if a zero interval is entered.) A
...) screen appears.
arrows to set a start-time value.
and/or
cycles (to activate
and press Enter again. When the
,
arrows to set the
because there is a nonzero span interval defined.
Entering the Password
Model 3010
): Press
(or
field to
. You can
pass-
TA
)
Advertisement
Chapters
Table of Contents
