Electrical Connections - Teledyne 3010TA Operating Instructions Manual

Oxygen Analyzer
open when the button in the center of the latch (upper right corner) is pressed
all the way in with a narrow gauge tool (less than 0.18 inch wide), such as a
small hex wrench or screwdriver Allow clearance for the door to open in a
90-degree arc of radius 7.125 inches. See Figure 3-3.
3.3
Figure 3-4 shows the Control Unit rear panel. Connections for power,
communications, and both digital and analog signal outputs are described in
the following paragraphs. Wire size and maximum length data appear in the
Drawings at the back of this manual.
Figure 3-4: Rear Panel of the Model 3010 Control Unit
For safe connections, ensure that no uninsulated wire extends outside of
the connectors they are attached to. Stripped wire ends must insert com-
pletely into terminal blocks. No uninsulated wiring should be able to come in
contact with fingers, tools or clothing during normal operation.
Figure 3-3: Required Front Door Clearance

Electrical Connections

Part I: Control Unit
Part I: 3-3