Teledyne 3010TA Operating Instructions Manual page 16

1 Introduction
• Power Connection
• Analog Outputs
• Alarm Connections
• RS-232 Port
• Remote Probe
• Remote Span/Zero
• Calibration Contact
• Range ID Contacts
1-4: Part I
Figure 1-2: Model 3010TA Rear Panel
Universal AC power source.
0-1 V dc concentration and 0-1 V dc
range ID. Isolated 4-20 mA dc and 4-20
mA dc range ID.
2 concentration alarms and 1 system
alarm.
Serial digital concentration signal output
and control input.
Provides all electrical interconnect to the
Analysis Unit or Remote Probe.
Digital inputs allow external control of
analyzer calibration.
To notify external equipment that
instrument is being calibrated and
readings are not monitoring sample.
Four separate, dedicated, range relay
contacts. Low, Medium, High, Cal.
Model 3010
TA