Chapter 1: Installing User Software On A Windows Computer; Setting Up Postscript Or Pcl Printing With Windows 98/Me - Fiery EX2101 Installation Manual

1

1-1 Setting up PostScript or PCL printing with Windows 98/Me

Chapter 1:
Installing
User Software
on a Windows
Computer
This chapter describes the procedures for installing the EX2101 software and setting
up printing from a computer using a supported version of Windows. For Windows
versions supported, see the
The general steps for installing the software are as follows:
• Install the PostScript printer driver or PCL printer driver and corresponding printer
driver files, and set up the printer driver to communicate with the Fiery EX2101.
• Install Fiery utilities and user software—Fiery Downloader, Fiery VDP Resource
Manager, Fiery Spooler, EFI Job Monitor, Fiery Printer Delete Utility, Hot Folders,
and Command WorkStation.
• Configure the connection for Fiery utilities and user software.
• Copy additional files from the User Software CD as required.
Setting up PostScript or PCL printing with
Windows 98/Me
To set up the Fiery EX2101 as a PostScript or PCL printer, you must install the
PostScript or PCL printer driver for Windows 98/Me and the corresponding printer
description files. You must also configure either a local connection for printing directly
or a network connection for printing over the network.
Using the PostScript driver requires either the hard disk option or the PostScript
N :
OTE
option installed on the copier.
If you are printing using SMB (Server Message Block), you can connect to the
Fiery EX2101 and install the printer drivers in a single procedure. For more
information, see "Setting up SMB printing with Windows 98/Me"
Quick Start Guide.
on page 1-9.