Adjusting Sleep Mode - Fluke Ti20 User Manual

Adjusting Sleep Mode

Sleep mode is used to conserve battery life if the Imager is turned on but not being used.
If you turn Sleep mode
mode is enabled, the Imager will automatically power down after the specified time
period.The default Sleep mode time period is 15 minutes.
1. From the Home display, press G (
Alarm and Sleep Mode display.
2. Press H (
3. Press F (4) to move the choice box left or H (5) to move the choice box
right. Options are 5, 15, 30, 60 minutes or
4. Press G (
, the Imager will run until the battery is depleted. If Sleep
OFF
) to access the Sleep Mode Adjust display
SLEEP
) to return to the Home display.
DONE
Advanced Imager Operation
) four times to navigate to the Adjust
MENU
.
OFF
Adjusting Sleep Mode
dag127f.bmp
3
3-9