Entering The Password - Teledyne 3000MA Operating Instructions Manual

4 Operation
If you have decided not to employ password security, use the default
password . This password will be displayed automatically by the
microprocessor. The operator just presses the Enter key to be allowed total
access to the instrument's features.
NOTE: If you use password security, it is advisable to keep a copy of
the password in a separate, safe location.
4.3.3.1
To install a new password or change a previously installed password,
you must key in and ENTER the old password first. If the default password
is in effect, pressing the ENTER button will enter the default
password for you.
Press System to enter the System mode.
Use the < > arrow keys to scroll the blinking over to
Enter to select the password function. Either the default
place holders for an existing password will appear on screen
depending on whether or not a password has been previously installed.
The screen prompts you to enter the current password. If you are not
using password protection, press Enter to accept
password. If a password has been previously installed, enter the password
using the < > arrow keys to scroll back and forth between letters, and the
arrow keys to change the letters to the proper password. Press Enter to enter
the password.
If the password is accepted, the screen will indicate that the password
restrictions have been removed and you have clearance to proceed.
In a few seconds, you will be given the opportunity to change this
password or keep it and go on.
4-6

Entering the Password

or
Teledyne Analytical Instruments
Model 3000MA
Contrast Function is DISABLED
(Refer to Section 1.6)
, and press
password or
as the default