A&D TN-2655 Instruction Manual page 17

8. When the measurement is complete, the air is automatically
released from the cuff and the cuff will become loose.
9. The measurement results appear in the display.
10. (TM-2655P) The measurement results are output to the
printer.
To stop the measurement at any time, press the START/STOP switch. The quick exhaust will
reduce the pressure in the cuff and the cuff will become loose.
If the air is not exhausted even when the START/STOP switch is pressed, press the
EMERGENCY STOP switch.
If your arm can not be removed from the cuff due to the power failure, press the safety lever
located on the front lower part of the device. It disconnects the clutch to loosen the cuff.
Please wait for about 10 minutes before repeating the measurement.
Note
11
Fig.9 Measurement results