Printing The Set Conditions - Mitsubishi P91W Operation Manual

Printing the set conditions

You can print the set conditions of BRT, CONT and GAMMA
under the image.
1 Turn on the power.
Press the "POWER" switch to turn on
•
the power.
2 Make a setting to print the set conditions.
While holding down the "}" of BRT
•
button, press the "{" of BRT button for
approx. 3 seconds till a "Peep" sounds.
" " is displayed on the indicator.
BRT CONT
OPEN
To select whether the printing conditions
•
are printed or not, press the "}" or
"{" of CONT button.
" " or " " is displayed on the indicator.
mode
Printing
Not printing
The set mode will not be lost even if the power is turned off.
PRINT
PRT-SIZE GAMMA COPY/FEED
indicator
3 Set to the stand-by status.
While holding down the "}" of BRT
•
button, press the "{" of BRT button
for approx. 3 seconds till a "Peep" sounds.
" " is displayed on the indicator.
BRT
OPEN
4 Print the set conditions.
Press the "PRINT" button.
•
Refer to the pages 11 to 12 for
printing procedure.
Example
A
18
CONT PRINT
PRT-SIZE GAMMA COPY/FEED
BRT:-3 CNT:+8 GMA: 5
Set conditions