Table of Contents
Advertisement
Clean this unit as following steps every 10 rolls of sheet.
Make sure to turn off the power first.
1 Cleaning paper guide shaft.
1
1
1
1
The seal paste is stuck on the ditch part of the shaft if you use it for a long time.
Wipe with tissue paper etc. which is soaked in a small amount of alcohol carefully.
The black surface is coated with Teflon. Do not touch it with metals.
2 Cleaning paper end sensor.
2
2
2
2
Wipe the dust with cotton buds which is soaked in a small amount of alcohol.
3 Cleaning rubber roller.
3
3
3
3
The seal paste and dust etc. are stuck on the rubber roller if you use it for a long
time.
Wipe with tissue paper etc. which is soaked in a small amount of alcohol carefully.
4 Cleaning print outlet.
4
4
4
4
The seal paste may be stuck on the paper guide inside or dust may comes from
the print outlet.
Use the optional cleaning kit to clean inside as the picture shows.
Do not use alcohol etc. when cleaning the print outlet.
NOTE
NOTE
Ditch part of shaft
Rubber roller
Shaft
Paper end sensor
1
2
Slide the kit to "1" direction
with moving "2" direction.
25
Advertisement
Table of Contents
