Table of Contents
Advertisement
[Calling a registered grouping]
To call a grouping, use any of four methods as follows:
When a grouping is called, the name of the grouping is displayed on the title bar of the main window. Further, the
contents of the drop-down list and the camera name tree on the camera list window are changed at the same time.
• Calling using the grouping list
Click the Grouping button on the main window (
Select a grouping and click the [Load] button.
• Calling using the camera list
Select a grouping from the drop-down list on the camera list window (
• Calling using F (function) keys
The first 12 groupings from the top of the grouping list are allocated to F keys of the keyboard. Press an F key
while holding down the Ctrl key to switch the grouping. Groupings are allocated to F keys in order from the top
of the groping list down.
• Calling using the grouping panel
You can allocate groupings to eight buttons on the lower tier of the grouping panel (
For the procedure of allocation,
[System Restart Grouping]
You can specify a grouping that is used at the start of the network function of this software.
4.9.6
Sequentially displaying using registered layouts <Patrol function>
By clicking the Patrol button on the camera list window (
switched and displayed at a fixed interval. When the patrol function is started, the color of the Patrol button
changes. You can delete already registered groupings to exclude them from sequential display or change the
interval of sequential display by changing the settings on the Camera List tab on the Option window (
4.18.4 on page 38).
Tips
• When you use the patrol function, it takes longer for this software to complete switching groupings if they
contain deferent recorders each. This is because this software needs to access and disconnect those recorders
at every switching. Register groupings using the following measure to shorten the switching time.
When there are recorders of which cameras don't need to be displayed at all, register a grouping with those
recorders connected.
see 3.3 on page 9) to display the grouping list.
see 4.9.7 on page 27.
see 3.4 on page 10), registered groupings are
– 26 –
Grouping button
[Load] button
see 3.4 on page 10).
Drop-down list
see 3.9 on page 13).
Put a checkmark in the box of the
grouping that is used at the start of the
network function.
see
Advertisement
Table of Contents
