Telnet Setup (Telnet Enabled Projectors Only); Displaying The Telnet Setting Screen - Mitsubishi Electric LAN Control Utility User Manual

11. Telnet setup (Telnet enabled projectors only)

You can set the password, ProjectorView display language, LAN control, and PJLink certification by running
Telnet on the projector screen.
Telnet is not available when using other than the projectors listed on page 30.
For more information on Telnet, see the LAN Control Utility manual that comes with the projector.
<Note>
• By default, Telnet is disabled on Windows Vista or Windows 7. To enable Telnet, go to Control Panel and select
[Programs and Features]. In the left column, select [Turn Windows features on or off] and then check the box
next to telnet.

11.1. Displaying the Telnet setting screen

(1) Select the projector that you want to configure on Telnet from the list of projectors on the
main screen.
• Run Telnet on one projector at a time. Multiple projectors cannot be set simultaneously.
(2) Click [Telnet] in the toolbar on the main screen.
• A command prompt starts.
• An error message appears if the selected projector is not Telnet enabled.
(3) Press the [Enter] key when the above screen appears.
<Note>
• Press the [Enter] key within five seconds. If not, the connection is terminated and the [Enter] key is not
recognized. If this happens, exit the command prompt and start it again.
(4) Setup menus appear.
EN-29