Ip Address Settings - Mitsubishi Electric DLP HC7800D User Manual

Initial network settings (continued)
6. Enter the NEW NETWORK PASSWORD and
CONFIRM NETWORK PASSWORD.
• Password can be set using up to 32 characters
including alphabets (capital/small) or numeric
characters.
← key: ............. Shifting the position of enter
cursor to the left for each
character.
→ key: ............. Shifting the position of enter
cursor to the right for each
character.
key: ............... Shifting the position of
enter cursor between NEW
NETWORK PASSWORD
and CONFIRM NETWORK
PASSWORD.
DEL key: .......... Deleting the character in the
position of enter cursor for each
character.
caps/CAPS key: Switching an alphabet character
to CAPITAL or small.
CLEAR key: ..... Deleting all the entered
characters.
7. When NEW NETWORK PASSWORD and CONFIRM
NETWORK PASSWORD are matched, the setting
is completed after changing the NETWORK
PASSWORD.
• When you select OK and the passwords you
entered are matched, the setting change dialog
is displayed. After the dialog disappears, the
NETWORK menu is displayed.
• When you select CANCEL, the NETWORK menu
is displayed without changing the password.
• If the entered content is not matched, NEW
NETWORK PASSWORD screen appears again
after an error dialog is displayed.
• It may take some time to reflect the settings.
IP settings
(See page 29 for menu setting.)
1. Display the NETWORK menu.
2. Press the p or q button to select IP CONFIG.
IP CONFIG
3. Press the ENTER button.
• IP CONFIG menu appears.
1 2
1 2
NETWORK
IP CONFIG
DHCP
IP ADDRESS
SUBNET MASK
DEFAULT
GATEWAY
MAC ADDRESS
OK
opt.
ON
0. 0. 0. 0
0. 0. 0. 0
0. 0. 0. 0
Setting or clearing DHCP
1. Display the IP CONFIG menu.
2. Press the p or q button to select DHCP.
DHCP
3. Press the ENTER button.
• Confirmation dialog appears.
4. Press the t or u button to select ON
5. Press the ENTER button.
• When you select OK, the setting change dialog
is displayed. After the dialog disappears, the
NETWORK menu is displayed.
• To cancel the setting, press the MENU button.
• It may take some time to reflect the settings.
• When setting DHCP to ON, IP ADDRESS,
SUBNET MASK, and DEFAULT GATEWAY
cannot be set. If you set those settings, set
DHCP to OFF and perform the IP settings as the
following procedures.

IP address settings

1. Display the IP CONFIG menu.
2. Press the p or q button to select IP ADDRESS.
IP ADDRESS
3. Press the t or u button to select SET
4. Press the ENTER button.
• IP ADDRESS screen appears.
IP ADDRESS
5. Press the p, q,t, and u buttons to move the key
cursor, select the numbers to enter, and press the
ENTER button.
• Set the numeric value within the range from 0 to
255. However, set the numeric value for the final
octet within the range from 1 to 254.
← key:
→ key:
DEL key: Deleting the character in the position
CLEAR key:
EN-45
ON
DHCP : ON
OK : ENTER CANCEL : MENU
0. 0. 0. 0
192 . 168 . 0 . 10
← →
DEL
0 1 2 3 4 5 6 7 8 9 CLEAR
OK CANCEL
Shifting the position of enter cursor to
the left.
Shifting the position of enter cursor to
the right.
of enter cursor for each character.
Deleting all the entered
characters.
or OFF .
.