Viewing 3D Images - Mitsubishi Electric DLP HC7800D User Manual

Viewing 3D images

With the separately sold 3D glasses (EY-3DGS-78U),
you can enjoy viewing 3D images on this projector.
To view 3D images, install the supplied 3D emitter.
Installing the 3D emitter
1. Unplug the power cord of the projector.
2. Place the supplied non-slip sheet on the bottom of
the 3D emitter.
3D emitter
3. Connect the 3D emitter terminal on the 3D emitter
to the 3D SYNC terminal on the projector using the
supplied mini DIN 5-pin cable.
To 3D emitter
terminal
Mini DIN 5-pin cable
4. Plug the power cord of the projector into the wall
outlet and turn on the power.
• The indicator on the 3D emitter will light green
and the 3D emitter will be ready to communicate
with the 3D glasses.
5. Adjust the position and angle of the 3D emitter so
that the 3D glasses can receive the infra-red signal.
• The traveling distance of the infra-red signal
from the 3D emitter is about 10 m in straight line
from the front of the infra-red transmission part.
• You can adjust the angle of the infra-red
transmission part as shown below. Loosen the
knob to adjust the angle and after finishing the
adjustment, tighten the knob.
Infra-red
transmission
part
• Secure the 3D emitter using the supplied 3D
emitter securing screws as necessary.
Non-slip sheet
To 3D SYNC
terminal
Knob
Important:
• Do not put any object which obstructs the
communication between the 3D emitter and the 3D
glasses.
• Do not place the 3D emitter near the remote control
sensor of other devices.
• The transmission distance is decreased when the
infra-red signal from the 3D emitter is transmitted
to the 3D glasses by reflecting on the screen. In
addition, the transmission distance in such case
varies depending on the characteristics of the
screen.
EN-25