Table of Contents
Advertisement
How do I Store a Profile?
A stored PROFILE is merely a "Snap-Shot-In-Time" for all settings which have been selected
from both the SETUP MENU options (LCD), or the USER MENU (OSD) options, within the
DVP1080 processor, and programmed into the processor's CPU.
System SETUP MENU Option (LCD)
• Enter the SETUP MENU by pressing Menu on the IR remote for seven seconds
• Select all applicable changes required for the intended PROFILE within the SETUP MENU
• Press Menu to exit the SETUP MENU
• Then, proceed to...
On-screen USER MENU Options (OSD)
• Press Menu to view the On-Screen Display (OSD)
• Adjust all applicable changes required for the intended PROFILE
• Under the menu tab INPUT, use V to highlight PROFILE
• Press the > to select numeric PROFILE
• Press Store.
• Press Menu to exit the On-Screen Display.
When I select 4:3 on the IR remote, the image is not centered
This essentially means the innate 16:9 image from the DVP-1080, when selecting
ANAMORPHIC, is not properly centered on the display device.
• Utilize a DVD 'Screen Area' test pattern (DVD Essentials, AVIA, etc.)
• Center, and position the image for a 2.5% over-scan, using the displays sizing and
positioning controls.
• Once the image has been properly centered, sized and positioned (utilizing the display
controls), the 4:3
image will fall-in-to-place and be centered within the 16:9 display area.
Note: Do not view a 4:3 images for prolonged periods of time on a 16:9 display; image
Burn-In may occur. Image Burn-In is not covered under the warranty.
The DVP-1080 has locked up. How do I reset the processor?
There are three options available to re-boot the processor.
Level ONE
Set the DVP-1080 unit in Stand-By mode; LED indication is RED. Disconnect the power
plug from the processor; reconnect the power plug to the processor and allow the unit to
re-boot.
Level TWO
• Enter the SETUP MENU by pressing Menu on the IR remote for seven seconds
• Press A on the IR remote once
• LCD display will indicate SET: RESTORE FACTORY / <PRESS STORE KEY>
• Press Store on the IR remote
• Front Panel LCD display will indicate ARE YOU SURE?
• Press Store again to confirm
Note: This action will clear all programmed PROFILES and reset the DVP-1080 to Factory
Defaults.
Level THREE
Connect to the DVP-1080 RS-232 CONTROL port using Windows HyperTerminal program
and a standard Modem Cable).
TYPE dvp,setft R denotes a carriage return, or pressing R button on the keyboard
Note: This action will clear all programmed PROFILES and reset the DVP-1080 to Factory
Defaults
T r o u b l e s h o o t i n g
Advertisement
Table of Contents
