Enabling Or Disabling Video Inputs; Configuration Settings - Meridian DVP1080MF User Manual

Enabling or disabling video inputs
To enable or disable the video inputs
• Select the appropriate input option:
SET: VIDEO INPUT
ENABLE
• Press < or > to change the input between ENABLE and DISABLE.
The following inputs are available: VIDEO, S-VIDEO, RGB, YCrCb, DVI, and PASS-
THROUGH.
To set the DVI input H-sync
Sets the DVI sync position to normal or wide:
SET:DVI INPUT H
NORMAL
Only available when the DVI input is selected and a video HD rate input is detected.
With some non-standard DVI sources selecting WIDE will correct improper sync timing
seen as a horizontal image shift.
SYNC
Configuration settings
The following settings effect the general configuration of the unit and the control inputs
and outputs:
Setting Description
OSD Can be switched between
the on-screen display.
OSD TIMER Can be set to between 0 and 255 seconds (default 30).
VFD TIMER Specifies how long the front panel display stays on after an
operation. Can be set to 0 (off), 1-254 seconds, or 255 = always on
(default 30).
VFD TIMEOUT LVL Sets the brightness level of the front panel display after the VFD
TIMER period has elapsed.
ON OFF
RS232 ECHO Can be set to or
are sent back to the RS232 control device.
BAUD RATE 9600 19200
Can be set to ,
RS232 communication baud rate.
SCREEN TRIGGER Can be set to OFF or
the 12V external trigger.
DVP1080MF is powered up and
ON OFF
and to certify the presence of
to determine whether command echoes
57600
(default), or to specify the
ON (default) to determine the operation of
OFF
takes the 12V output low when the
ON
takes it high.
 
C o n f i g u r i n g t h e
d i g i t a l v i d e o
p r o c e s s o r