Remote Control - Meridian DVP1080MF User Manual

 
O p e r a t i n g t h e
d i g i t a l v i d e o
p r o c e s s o r
Remote control
Digital video projector
operation
The remote control operates both Meridian
DILA projectors and DVP digital video
processors.
• Press DVP or DILA to select the product
you want to control.
• Point the infra-red light at the top of the
remote control towards the product you
want to control.
The digital video processor has a sensor on
the front panel.
The projector may have sensors at the front
and rear; see the projector user manual
for details. In addition, you may be able to
control the projector by pointing the remote
control at the screen so the beam reflects
back to the projector.
To work reliably the angle of the beam
needs to be within ±30° of centre, and
the total distance needs to be less than 7
metres.
Select projector
Select processor
DVP DILA
Reset a selected menu item
Profile
to factory setting
Preset
Navigate menus
Enter
Select menu item
Return from menu
Bypass
Exit
DVI
Video S-Video
Select aspect ratio
Anamorphic 4:3
Adjust colour
Colour Tint
using < or >
1 2
Display green grid signal
for focus adjustment
Pattern Focus
4 5
7 8
Hide/restore video image
Hide Zoom
0
Adjust brightness
Bright.
using < or >
Illuminate backlight for 10
Lig ht
seconds
Turn processor/projector on
On
Turn processor/projector
Off
to standby.
Hold down or switch
Store
projector to cool-down
mode
Display/hide menu
Menu
YCrCb
Select video input
RGB
Adjust NTSC tint
Letterbox
using < or >
Detail
Adjust image detail
using < or >
3
Adjust projector focus*
6
9
Display test patterns
T
Zoom projector image*
Test
W
Cont. Adjust contrast
using < or >
* Only available with
some projectors
To replace the batteries
Before use, load 3 AAA size batteries into
the remote control. If the remote control
starts to function erratically, replace the
batteries.
• Gently press the circular recess near the
top of the battery cover on the back of
the remote control.
• Slide the cover down and off.
• Insert three penlight cells by pressing
the negative terminal of each battery
against the corresponding spring and
snapping into place.
Alkaline cells types AAA, UM04 or IECR03
are recommended.
The correct orientation of the batteries is
indicated in the battery compartment.
Replace the battery compartment cover and
slide it upwards, engaging the two tabs at
the top of the cover with the slots provided
at the top of the compartment.
• Push the cover up until it clicks shut.
When correctly engaged, the cover should
sit flush with the rear of the remote control.