Lenovo ThinkServer RD630 Hardware Maintenance Manual page 179

5. Ensure that the cover latch is in the open position. Place the server cover above the chassis so that
the cover latch is aligned with the cover latch slot in the chassis. Then, lower the server cover onto
the chassis until the cover latch is inserted into its slot and both sides of the server cover engage the
guides on both sides of the chassis.
Figure 132. Installing the server cover
6. Pivot the cover latch
same time until the server cover snaps into position and the cover latch is completely closed.
Figure 133. Closing the server cover completely
7. Install the server into a rack cabinet using the rail kit that comes with the server. See the Rack Installation
Instructions that comes with the server.
8. Reconnect external cables and power cords to the server. See "Rear view of the server" on page 25 to
identify the connectors on the rear panel of the server.
1 to the closed position and slide the server cover to the front of the chassis at the
.
Chapter 6 Installing, removing, or replacing hardware
165