Removing A Memory Module - Lenovo ThinkServer RD630 Hardware Maintenance Manual

9. Position the new memory module over the memory slot. Ensure that the notch
module is aligned with the key
into the memory slot until the retaining clips close and the new memory module snaps into position.
Note: If there is a gap between the memory module and the retaining clips, the memory module has
not been correctly installed. Open the retaining clips, remove the memory module, and then reinstall it
into the memory slot until the retaining clips are completely closed.
Figure 50. Installing a memory module
10. Reconnect any cables that you have disconnected.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 163.

Removing a memory module

Attention: Do not open your server or attempt any repair before reading and understanding "Safety information"
on page iii and "Guidelines" on page 71.
This topic provides instructions on how to remove a memory module.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Note: Ensure that you consider and follow the memory module installation rules when performing the
operation. See "Memory module installation rules" on page 82.
To remove a memory module, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See "Removing the server cover" on page 73.
4. Remove the cooling shroud. See "Removing and reinstalling the cooling shroud" on page 78.
5. Locate the memory slots on the system board and read the memory module installation rules. See
"Memory module installation rules" on page 82.
88
ThinkServer RD630 Hardware Maintenance Manual
2 in the memory slot. Then, press the new memory module straight down
1 on the new memory