Manual Setting; Lcd Contrast Setting; Manual Time Setting; 12/24 Hour Time Display Setting - La Crosse Technology WS-1516-IT Instruction Manual

Time display
Wind Chill
in °F or °C
Outdoor temperature or dew point
in °F or ºC
Outdoor temp.
alarm icon
Relative air pressure
display in inHg or hPa, or
total and 24h rainfall
display in inch or mm
Air pressure
histogram
Low battery Indicator (Thermo-hygro)
Mode 2 : Wind Gust, Dew Point temperature and 24 Hour and Total Rainfall reading are shown.
Dew point icon
Rainfall icon

MANUAL SETTING:

The following manual settings can be changed once the SET key is pressed and hold for about 2
seconds:

LCD contrast setting



Manual time setting


12/24 hour time display

Calendar setting

°F/ °C temperature unit setting

Wind speed unit

Rainfall unit setting

Air pressure unit setting

Relative pressure reference value setting

Weather tendency threshold value

 Storm warning threshold value
 Storm alarm On/ Off setting
Time alarm icon
Calendar, indoor temp.,
or alarm time display
Buzzer off indicator
Wind direction display
and wind speed in
Beaufort scale
Wind speed Hi
alarm icon
Wind speed or gust
in mph, km/h or m/s
Outdoor relative
humidity in %
Outdoor Humidity
alarm icon
Transmitter signal
reception icon
Weather tendency
indicator
Weather forecast
icon
Low battery Indicator (rain sensor)
17
Wind gust icon
In Mode 2, this
reception icon is
showing the condition
of the reception of the
signal from Rain
sensor
19
* When the signal from the transmitter/ or Rain sensor is successfully received by the Weather
Station, this icon will be switched on. (If not successful, the icon will not be shown on the LCD).
User can therefore easily see whether the last reception was successful ("ON" icon) or not
("OFF" icon). On the other hand, the short blinking of the icon shows that a reception is being
done at that time.
*In normal display user may press the SET key shortly to toggle between Mode 1 and Mode 2
display:
Mode 1 : Wind speed, outdoor temperature and relative pressure reading are shown.
Outdoor temp
icon
Rel Pressure
icon
LCD CONTRAST SETTING
The LCD contrast can be set within 8 levels, from "LCD 1" to "LCD 8" (default setting is LCD 5):
1. Press the SET key, the contrast level digit will start flashing.
2. Use the + or MIN/MAX key to adjust the level of contrast.
3. Confirm with the SET key and enter the MANUAL TIME SETTING.
MANUAL TIME SETTING:
You then may manually set the time of the clock by following the steps below:
Minutes flashing
Hour
flashing
1. The hour digit will start flashing.
2. Use the + or MIN/MAX key to set the hour.
3. Press the SET key to switch to the minutes. The minute digit will start flashing.
4. Use the + or MIN/MAX key to set the minute.
5. Confirm the time with the SET key and enter the 12/24 HOUR TIME DISPLAY SETTING.

12/24 HOUR TIME DISPLAY SETTING:

Wind speed icon
In Mode 1, this reception
icon is showing the
condition of the
reception of the signal
from Thermo-hygro
transmitter
18
Flashing
Digit flashing
20