Table of Contents
Advertisement
Components connected to the D.AUDIO IN terminal
Symptoms
The main unit and
remote control can-
not control a Kenwood
digital audio player.
Remote control
Symptoms
The remote control does
not work.
Resetting the microcomputer
Symptoms
Microcomputer mal-
function (the system
does not work, the
display is faulty, etc.).
Solution
Connect the player using the dedicated cable PNC-150.
Check whether the connected model is compatible.
Solution
Load new batteries.
Use the remote control within its eff ective range.
Malfunctions may occur due to an external cause or because a connec-
tion cord was unplugged while the system was turned on.
Use the procedure below to reset the microcomputer.
1 Unplug the power cord from the AC
wall outlet.
2 Plug the power cord back in while
holding down the power [K] key on
the main unit.
3 Upon the start of the microcomputer
resetting, the display shown on the
right appears.
During the resetting of microcomputer,
the display goes out.
4 When fi nish resetting, it turns to
Standby Mode.
Bear in mind that resetting erases any
stored information and restores the
system's default settings.
Ref. page
Ref. page
Solution
Troubleshooting
12
44
17
17
71
English
Hide quick links:
Advertisement
Chapters
Table of Contents
