Using Foot Switches To Perform Button Operations (Foot Switch) - Roland V-DRUMS TD-10 Owner's Manual

Chapter 9. Operations using pads and pedals
* If you do not want to trigger instrument sounds assigned to the pads, press [CONTROL ROOM]-[F1
(MIXER)]-[F1 (VOLUME)], and set the volumes of AUX 1 and AUX 2 to "0."
* If the "Mode" setting is "KIT SELECT" or "PATTERN SEL," striking the rim of the pad will have the
same function as pressing [DEC].
* If you wish to use Drum Kit Chain (p. 70) to select kits, set the above "MODE" parameter to "KIT
SELECT," and press [CHAIN] to make the button indicator light. (Create your Drum Kit Chain settings
first.)
Using foot switches to perform button opera-
tions (Foot Switch)
Two foot switches (BOSS FS-5U, optional) and a special cable (PCS-31) can be used to operate the
TD-10. Set "Mode" to specify the function of the two pedals.
fig.10-03
Procedure
1. Connect the foot switch to the FOOT SWITCH jack.
2. Press [SETUP]-[F3 (CTRL)]-[F1 (FOOTSW)].
The "FOOT SWITCH" page will appear.
3. Use [INC/DEC] or the VALUE dial to select the combination of functions that the foot switch will
perform (refer to the following table).
4. Press [EXIT] to exit this page.
5. Press the foot switches, and they will function as switches.
Parameters
Mode (function name)
KIT SELECT
PATTERN SEL
PATTERN PLAY
* To use foot switches to select kits using a Drum Kit Chain (p. 70), set the above "MODE" parameter to
"KIT SELECT," and press [CHAIN] to make the button indicator light. (Create your Drum Kit Chain set-
tings first.)
120
Foot switch
FS-5U x 2 (PCS-31)
DP-2
SW1
Select the previous kit
Select the previous pattern
Select the next pattern
SW1 SW2
o (red) o (white)
- o
o: Function -: Not function
SW2
Select the next kit
Select the next pattern
Playback/stop the pattern