Changeover Of WTh/WThout Knot-TyNg; Maintenance, Subclass Models And Attachments; How To Connect The Metal Fittings Of The Belt; Subclass Models - JUKI MB-1373 Instruction Manual

(4) changeover of with/without knot-tying
1
1

4. MaINtENaNcE, SuBcLaSS MoDELS aND attacHMENtS

4-1. How to connect the metal fittings of the belt

1

4-2. Subclass models

MB-1373
8, 16, 32 sttches
To make "wth knot-tyng", pull knot-tyng changeover
knob 1 toward the front and place t to the poston
in the figure.
To make "wthout knot-tyng", pull knot-tyng change-
over knob 1 toward the front and place t to the
position in the figure.
Tghten connectng screws 1 of the belt so that the
screws protrude approxmately 1.5 to 2 mm from the
reverse sde as the standard.
1. When assembling the belt to the pulley
and rotating the motor after closing the
side cover, confirm that the side cover
does not interfere with the metal fitting of
the belt.
2. take care not to allow the belt to be
clogged with oil when assembling it.
MB-1373-11
8, 16, 32 sttches
– 11 –