Specifications Of Tl-2010Q/2000Qi - JUKI TL-2010Q Service Manual

[1] SPECIFICATIONS OF TL-2010Q/2000Qi

(1) Power switch
ON•OFF 2-step changeover switch (common to lamp) located at the belt cover section of the right-hand
side of main unit.
(2) Drive control components
Drive : Built-in motor timing belt method
Control : Foot pedal controller method 50 to ,500 sti/min
Low speed rotation of 50 sti/min while needle up/down switch is ON
(3) Table, stand and handle components
Main unit : Portable type main unit with soft case (Case is folded in two and packed with main unit.)
One-touch type auxiliary table knee lifter is provided as standard. (Packed together)
Handle : Pull-up/down from machine main unit type
Table/stand: Separately sold fully-sunken type table and stand can be used.
(4) Arm and bed components
Material : Aluminum die casting arm and bed separate body type
Bed form : Flat bed portable type
(5) General mechanism
. Thread take-up : Slit type link thread take-up for one-touch threading
2. Hook
3. Pressing pressure adjustment
4. Lighting device
5. Needle thread post
6. Bobbin thread winder
7. Needle thread threading
8. Presser foot
9. Lift of presser foot : By lever
10. Thread tension
. Drop feed
2. Power switch
(6) Feed mechanism
. Feed amount adjustment
2. Reverse feed stitch
: DB type horizontal full-rotary hook
: Stepless adjusting screw with pressing pressure indicator method
: Built in face cover Switch : Slide type Lamp : Halogen lamp
: Two posts for small thread spool and large thread spool
Thread guide of thread post is of draw-out type and capable of
one-touch threading
: One-touch action : Starting method by controller Automatic stop when
bobbin thread winding completed
: One-touch threading from thread spool to needle tip
: Commercially-available presser foot for industrial sewing machine
(SL2) can be used. (Setscrew type)
: 7 mm Max. by lever : 0 mm By knee lifter : 2 mm
: Disk pressure adjusting type with simplified disk pressure scale
: 2-step changeover by knob method (Feed dog : UP : DOWN)
: ON • OFF 2-step
: Dial method ...... Stepless 0 to 6 mm
: Lever method .... Feed amount conforms to that of normal feed stitch.

– –