JUKI TL-2010Q Service Manual page 5

(7) Special mechanism
. Automatic thread trimming
2. Needle bar stop position
3. Automatic needle hole threading : Hook section rotates and automatically returns by lowering threading
4. Needle up/down switch
5. Prevention of reverse setting of needle
6. Motor protection
Overcurrent
Overheat
(8) Dimensions and weight
Main unit : 452W x 29L x 350H (mm)
Weight : .5kg
(9) Power consumption
Whole sewing machine
: Thread trimming switch is used in common for pushbutton type and
for external foot pedal switch type.
Switch fails to work even when pressing it within two seconds after
the rotation of thread trimmer.
: Electric brake stop method
Stop by controller
Stop by automatic thread trimming
Stop by bobbin winder
lever.
: Switch is of pushbutton type and up/down stop can be performed by
half rotation of main shaft when operating switch for a short period of
time. When switch is continuously held ON, sewing machine
continuously runs at a speed of 80 sti/min until switch is turned OFF.
: Needle is attachable to normal direction only.
: When motor is locked for 0.5 to  second due to sudden overload,
motor power is automatically turned OFF and returns to the ON state
immediately.
: When motor temperature has abnormally risen, motor power is turned
OFF(thermal cut) and returns to the ON state when temperature has
fallen.
: 20V .4A 60Hz
–
2
–
: Down stop
: UP stop
: UP stop