Introduction; Specifications; Cutting Capacity - Jet JMS-10CMS Operating Instructions And Parts Manual

Introduction

This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and
maintenance procedures for the JET Model JMS-10CMS Compound Miter Saw with laser. This manual
contains instructions on installation, safety precautions, general operating procedures, maintenance
instructions and parts breakdown. This machine has been designed and constructed to provide years of
trouble free operation if used in accordance with instructions set forth in this manual. If there are any
questions or comments, please contact either your local supplier or Walter Meier. Walter Meier can also
be reached at our web site: www.waltermeier.com.

Specifications

Model Number ................................................................................................................... JMS-10CMS
Stock Number .......................................................................................................................... 707100
Motor ......................................................................................................................... 120V, 60Hz, 15A
No Load Speed (Arbor) .......................................................................................................... 4800RPM
Motor Arbor Shaft Size .................................................................................................................... 5/8"
Blade ............................................................................................................... 10", 40T, carbide tipped
Blade Arbor Size............................................................................................................................. 5/8"
Net Weight ................................................................................................................................33.3 lb.
The above specifications were current at the time this manual was published, but because of our policy of
continuous improvement, Walter Meier reserves the right to change specifications at any time and without
prior notice, without incurring obligations.

Cutting Capacity

Cut Type
Cross Cut
Miter
Bevel
Compound Cut
Vertical Capacity (Base
Board)
Read and understand the entire contents of this manual before attempting
assembly or operation! Failure to comply may cause serious injury!
Miter Angle Bevel Angle
0º 0º
45º Right & Left 0º
0º 45º Left
45º Right & Left 45º Left
--
Cutting Capacity
2-5/8" x 5-1/2"
2-5/8" x 3-1/2"
1-1/2" x 5-1/2"
1-1/2" x 3-1/2"
-- 4"
7
Cutting Capacity
with 3/4"
Auxiliary Fence
3-1/2" x 3-1/2"
3-1/2" x 2"
2" x 3-1/2"
2" x 2"