Opening The Automatic Plate Converter - Janome Horizon Memory craft 7700 QCP Instruction Book

z
x
c
v

Opening the automatic plate converter

The automatic plate converter should be open if any
pattern other than D1S, D2S or D3S is selected.
The APC setting window will open if a stitch pattern other
than D1S, D2S or D3S is selected while the automatic
plate converter is closed.
z If the bobbin thread is pulled out through the hole in
the plate converter, press the OK key under "Set" and
follow the instructions that appear in the APC setting
window.
NOTE:
Press the OK key under "Ready" to open the plate
converter if the bobbin thread has already been cut with
the automatic thread cutter.
x Hold the bobbin thread and press the OK key. The
bobbin thread will be trimmed automatically.
c Remove the tail of the bobbin thread and press the OK
key.
v The plate converter will open.
35