Darning - Janome Horizon Memory craft 7700 QCP Instruction Book

1
2
3
4

Darning

Machine settings
Pattern: 35 (Buttonhole)
Thread tension: AUTO
Presser foot: Automatic buttonhole foot R
Foot pressure: 7
When selecting the darning stitch, the LCD screen will
advise you to pull the button holder open.
Pull the button holder to the rear.
Insert the corner of the fabric under the foot. Press
the up/down needle position button twice.
Remove the fabric to the left to draw the needle thread
through the hole of the foot.
Place the fabric under the foot, and lower the needle
at the starting point. Then lower the foot.
1 Button holder
2 Starting point
Start sewing. The machine will sew a darning 2 cm (3/4")
long and stop automatically.
Repeat sewing in the different direction until the darning
covers the rip or hole.
NOTE:
The maximum size of darning is 2 cm (3/4") long and
0.7 cm (1/4") wide.
3 Maximum length 2 cm (3/4")
4 Maximum width 0.7 cm (1/4")
60