Janome Horizon Memory craft 7700 QCP Instruction Book page 54

c
1
v
2
5
9
10
8
3
4
6
7
10
c Pull the buttonhole lever down as far as it will go.
1 Buttonhole lever
NOTE:
If you start sewing without pulling down the buttonhole
lever, the LCD screen will show a warning and the
machine will stop after a few stitches. Pull the buttonhole
lever down and start sewing.
v Insert the corner of the fabric under the foot. Press
the up/down needle position button twice.
Remove the fabric to the left to draw the needle
thread through the hole of the foot.
Place the fabric under the foot, and lower the needle
at the starting point of the buttonhole mark.
Then lower the foot.
2 Buttonhole mark
3 Starting point
4 Bobbin thread
5 Needle thread
NOTE:
Make sure there is no gap between the slider and the
front stopper, otherwise the buttonhole will be off the
position or there will be a sewing gap.
6 Slider
7 Front stopper
8 Off the position
9 Starting point
10 Sewing gap
52