Table of Contents
Advertisement
6. Adjus琀椀ng the Base-Plate Feet
Figure 6.1
Figure 6.2
Janome-America.com
Tools required: (5 mm handle hex tool)
Check:
1. The base plate must be adjusted so that the rubber
feet will sit 昀氀at on a planed surface. Note: This is
done on a precision surface plate at the factory
during assembly ⸀
If a correc琀椀on is necessary: Thin shim washers may be
used as shown in (Figures 6.1 and 6.2).
Page 15
Advertisement
Table of Contents
